Skip to content

Black Travertine

Natural Stone Type: LIM

Finish: Polished + Filled

Product Details

Share

Care + Maintenance

  • Pre-Grouting Protection: Fila PRW200
  • Initial Cleaning: Fila PS/87
  • Protection Natural Effect: Fila Fob
  • Protection Color Enhancing: Fila Stone Plus
  • Standard Maintenance: Fila Cleaner
  • Special Maintenance: NA

Applications

  • Exterior Cladding: No
  • Exterior Pavers: No
  • Interior Walls: Yes
  • Interior Floors: Yes
  • Kitchen Countertops: No
  • Other Countertops: Yes
  • Wet Areas: Yes
  • Traffic: Yes
Important Information
Black Travertine slabs have a resin and mesh backing and therefore require an epoxy setting adhesive such as Latapoxy from Laticrete or similar. This is a fragile material. Use an experienced fabricator familiar with working and repairing these materials. Waste materials should be factored in to fabrication as repairs and reinforcements will likely need to be made. Complex cut to size projects are not advised. Travertine is a porous material with naturally-occuring holes that may remain unfilled or be factory-filled with resin or cement. Do not use resin-filled materials outside, as the resin will discolor over time. See the Applications Guide PDF for alternatives.
Abrasion Resistance

Low

This material has low abrasion resistance. It rates as a 1-3 on the Mohs scale. Light scratching will occur with exposure to sand and other abrasives. The finish will patina or dull over time as a result of this scratching. Always use a cutting board for countertop applications and walk-off mats at entrances in flooring applications.

Absorption

High

This material has a medium to high absorption rate. Always seal this material prior to use. Properly seal the material prior to grouting by applying several coats of sealant or until water beads up on the surface. Use Fila PRW200 to avoid staining from grout residues and specify a grout color that is similar to the color of the stone to avoid color bleeding into the material. Use low moisture setting materials. To reduce the appearance of stains, always wipe up spills immediately. Oil and highly-pigmented liquids can penetrate and stain the stone and may need poultice to remove the stain.

Acid Sensitivity

High

This material is highly sensitive to acids. Acid etching will be highly visible on this material when exposed to acidic foods such as lemons or tomatoes. Do not use this material on kitchen countertop applications where acid etching is a concern. If acid etching is a concern, select a minimally sensitive material.

Freeze-Thaw

Not Recommended

Due to known material weakness or because this material has not been tested, this material is not approved for use in exterior applications.

See Product